4/4/08 Carlos Arango

10:00am-01:00pm

1. Designed and machined spacers for battery box screws (3 hours)

-------------------------------------------------

1. After designing the spacers on Inventor, I went on a hunt for proper stock and found a small bar that had the exact outer diameter I needed. However, I found out that the chuck on the lathe was too small for the piece, so through some trial and error (I did not damage anything) I managed to remove it and put a bigger one in. After the first couple of spacers (which turned out the wrong size), i got the process down pat and was able to finish all 7 screw spacers

03/31/08 Nicole Rodia

3:45 - 6:00 pm

1. Finished finding parts for motor controller board
2. Future electronics team meeting
3. Prepared for populating motor controller board - using the microscope, where to find solder paste, etc.

3:30-5:45

1. Worked on the matlab data analysis

--------------------------------------------------

1. added a zoom in y feature using arrow keys.

2. Working on the video synchronization part of the data analysis.